Advertisements
Aquatic Avenue Banner Tropica Shop Banner Fishy Business Banner
Results 1 to 3 of 3

Thread: Help:DIY CO2 Reactor

  1. #1
    Join Date
    Jan 2002
    Posts
    29
    Feedback Score
    0
    Images
    4

    Help:DIY CO2 Reactor

    Advertisements
    Fresh n Marine aQuarium Banner

    Advertise here

    Advertise here
    Hi,

    I made the above from a powerhead and a clear plastic bottle.

    It works but over the weekend, the CO2 caused the powerhead to "airlock".

    I read about the bleed vent...where should that be?
    Attached Images Attached Images
    Teddy Ang
    "...equilibrium is a state of mind."

  2. #2
    Join Date
    Jul 2002
    Location
    Old Airport Road
    Posts
    1,890
    Feedback Score
    0
    Images
    67
    Country
    Singapore
    Hi Ted,

    From your picture, I don't think the powerhead is airlocked.
    Airlock is when air gets trapped in your filter / powerhead impeller hence affecting the spinning, usually accompanied by loud noises

    I think you're probably referring to the excessive collection of air bubbles in your bottle, this is perfectly fine, but if it an eye sore for you, you can try drilling a small hole as in the edit pic below.



    I believe, as the co2 accumulates, the air column will increase and will be able to escape from the drilled hole.
    - eric

  3. #3
    Join Date
    Jan 2002
    Posts
    29
    Feedback Score
    0
    Images
    4
    Thanks for the prompt reply!

    The pic was taken after i reset the powerhead.

    Ok, will drill a small hole for the bleed.

    Appreciate it.
    Teddy Ang
    "...equilibrium is a state of mind."

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •