Pressurised C02

[ZanPBB]

Hi guys. I just wanna know how do I perform a correct and safe method of Leak test on my Pressurise C02 system?


Sent from my iPhone using Tapatalk

[Punanister]

Spray soapy water on the connections. Careful on the solenoid part.

Sent from my SM-A710F using Tapatalk

[ZanPBB]

Spray soapy water on the connections. Careful on the solenoid part.

Sent from my SM-A710F using Tapatalk

U mean using soap water and spray on to the c02 pipes?


Sent from my iPhone using Tapatalk

[Punanister]

Yep. If it bubbles then that's where the leak is.

Sent from my SM-A710F using Tapatalk

[ZanPBB]

Yep. If it bubbles then that's where the leak is.

Sent from my SM-A710F using Tapatalk

Ok but how about the solenoid part? What safety precautions should I take?


Sent from my iPhone using Tapatalk

[Punanister]

Ok but how about the solenoid part? What safety precautions should I take?


Sent from my iPhone using Tapatalk

Well, since it's an electrical part, try not to get any of the water to it. Cover it with plastic wrap and do not spray too much.

Sent from my SM-A710F using Tapatalk

[ZanPBB]

So the main part of this test is concentrated more on the hoses right? Not the solenoid?


Sent from my iPhone using Tapatalk

[Punanister]

Yes and its connections.

Sent from my SM-A710F using Tapatalk

[Shadow]

I normally use sponge, those for washing dishes, put soap and water and use it to wipe the join.

Thing that I check:
- Tank to regulator join
- Needle valve - hose
- Check valve - hose
- buble counter - hose