I had a similar before. Its not about time to replace as they can last quite awhile.but it is perhaps a cause for concern.shouldnt be humming. Maybe can standby new one just in case.
Sent from my Android using Tapatalk2



Hi everyone,
Wanted to check if anyone else encountered this problem and if there is a solution.
My solenoid recently started having a loud hum when the power is on. I flipped the power on an off a few times and the sound of the hum reduces. It is a hit and miss though. Sometimes the humming sound is reduced sometime it is not.
The solenoid is about a year old. Is it time to replace?



I had a similar before. Its not about time to replace as they can last quite awhile.but it is perhaps a cause for concern.shouldnt be humming. Maybe can standby new one just in case.
Sent from my Android using Tapatalk2



Thanks for your reply bro. What did you do to solve you humming solenoid?

sounds like the locknut is loose.
look below the unit, if yours have a nut there. tighten it. i have a jbl unit that had the same issue.
a normal solenoid should have minimal vibration. but not audible.
Sent from my GT-N7105
Learning the hardway, not the highway.
Photo Blog - impervious-endeavors.blogspot.com
Semi-Active currently
"if he cant be bothered to take the time to write his question properly, why should I take the time to answer him."



Thanks for the reply. I will head home and give it a go. Was reading online and some say the it is the AC buzz which is normal and it is due to a lack of voltage reaching the solenoid. Will try all suggestion! I am sure there is something wrong as I have used it for a year and never noticed a buzz.

there should be a very slight humming inaudible after some distance, lets say 1m away from tank.
the jbl unit didn't have the sound when i initially got it from a bro in marketplace, only had the sound after 1+ months.
but when in doubt, just bring it over to lfs likely you can get it fixed (at a fee of course). But if tightening a nut solve the problem, you can spend the fee on more stuff.
This is what i mean. (Picture of mine when i stripped it)
![]()
Learning the hardway, not the highway.
Photo Blog - impervious-endeavors.blogspot.com
Semi-Active currently
"if he cant be bothered to take the time to write his question properly, why should I take the time to answer him."



Thanks bro Felix! I got it fixed
I didn't take the unit apart just tightened all the visible bolts on the external of the unit. From your picture I can't tell if the locknut circled out is internal or external.
I tighten the nut holding the electrical wire to the solenoid and another on the external body of the unit. Will monitor.
Hope this thread can help others too!

What you did was good enough, most important is the noise issue is fixed.
Learning the hardway, not the highway.
Photo Blog - impervious-endeavors.blogspot.com
Semi-Active currently
"if he cant be bothered to take the time to write his question properly, why should I take the time to answer him."
Bookmarks