To be honest, I'd rather you find out the cause of the death, bad water parameters? Bad feeding habits?(over or under feed) temperature? Or illness?
Sent from my GT-N7000 using Tapatalk 2
So my new tank isnt here yet...but while waiting for the new tank, the fish in the current tank seems unhealthy. One gouramis turned blind. The eyes became white..but it is still eating well.
Today one otto died. The hardy otto also can die! I feel like i am a murderer
The plants isnt doing well too. The whole tank is just wrong.
Can i remove plants and soil and just put the fish inside while waiting for the new tank to come? Will it shock the fish if suddenly there isnt any plants inside the tank?
keep on swimming...swim swim swim..
To be honest, I'd rather you find out the cause of the death, bad water parameters? Bad feeding habits?(over or under feed) temperature? Or illness?
Sent from my GT-N7000 using Tapatalk 2



If you disturb the substrate there may be toxic gases built up within the substrate and stirring it may release these toxins into the water. Anyway, seeing as how densely planted your tank is, don't disturb the tank too much while there are fish inside. I think you mentioned that you didn't really cycle your tank in your earlier thread? Introducing fish into an un-cycled tank is... usually fatal. What you need to do is get a few test kits. Ammonia, Nitrite and PH will do or just get the API master kits http://freshnmarine.com.sg/estore/pr...oducts_id=2084. Normally, I'll say a tank is cycled when it can bring down Ammonia and Nitrite levels from 2-3ppm to 0 within 24hours. If your fish are exposed to Ammonia or Nitrite previously, their health and lifespans are definitely affected no matter how hardy they are. Never ever wash your ceramic rings with tap water! If you want, give them a rinse in old tank water or you'll end up killing all the beneficial bacteria in your filter. For more information, read up on the nitrogen cycle and fishless cycling.
Please check your current tank parameters first. If you see any Ammonia or Nitrite in your tank then immediately do big water changes with dechlorinated water.
Thank you davincey! I will get that test kit!
keep on swimming...swim swim swim..



No problems. I had a lot of problems when I was starting out as well. I don't even want to think about the number of fish I killed last time...
But nice effort for your first planted tank. My first tank was just lapis sand with driftwood and java ferns![]()



If you are willing to learn it should be fine. Most shops don't tell you about cycling, nitrogen cycle and tank maintenance. Can't blame them though.... a lot of my friends expressed interest in fish keeping only to be put off by how "troublesome" it is. They thought it is just getting the equipment and putting the fish in immediately. Then I start telling them about cycling and stuff they decided not to anymore... Maybe I should have kept quiet about it and get them hooked into starting first and start advising them after they have purchased it![]()
If I had someone who can advise me before I start, i will start it the correct way and not get headache and stress now. But then again, if I don't make all these mistakes, I might not learn either. Poor thing the fishes has to die for me. One moment the fish is happily eating then the next day sink to the bottom and turned white. Its like the scene from titanic..the people died at the bottom of the sea and white too!
keep on swimming...swim swim swim..
you can actually speed up the tank cycling by borrowing a "used" or seasoned filter media from someone near you, but that's just a suggestion though. only downside for that is - water disease (heard about it somewhere before, correct me if i'm wrong) can be spreaded through the filter media as well



Bookmarks