Are there any plants? Which type of substrate are you using in the setup?
If in doubt, do water change since there's no fish in tank yet.. do a large amount might help


Hi guys,
Started fishless cycle for a week...
Realized from forum the importance to understand water parameters and hence, bought the API (freshwater) master test kit.
Readings i got (7th day):
PH = 6.5
Ammnonia = 0.25 ppm
Nitrite = 1 ppm
Nitrate = more then 80ppm..
The readings sort of shocked me..
Any reasons why the Nitrate is so high when there are no fishes in the tank ?
I looked at fishless cycle chart from here:
http://www.fishkeeping.co.uk/article...ng-article.htm
From the chart... shouldnt Nitrate begin to rise at the end of the fishless cycle ?
Dont think my tanks ready so soon.. any reasons for such a reading?
Advise is appreciated.
Thanks!
Are there any plants? Which type of substrate are you using in the setup?
If in doubt, do water change since there's no fish in tank yet.. do a large amount might help


Hi rakurime,
Yes, I had a couple of java fern windelov on a driftwood.
I am using OF aqua gro soil.
I did a 40% water change with added prime.. scared BB die from tap water.
maybe i will test the water few days later and see how the progress goes...
just a bit confused,, thats all.





It's normal to have a spike during cycling. Just change water to keep nitrate down.


Hi Ingen,
yup, did the water change.
I was hoping to determine where am in the nitrogen cycle, and to know whether i am in the right track (heard of stalled cycles).
Thanks.
The specific beneficial bacteria colonies that process ammonia to nitrite, and then nitrite to nitrate, grow and work at different speeds, so its common to see one parameter increase faster than the other. Its not a linear progression, each parameter can rise and fall independently.
If you are noticing consistently high nitrate levels (especially even after repeated water changes), also test your tap water parameters, some water sources may sometimes contain high nitrate levels.
Nitrate test readings can also be affected by how you perform the tests... for the API test kit, you need to really shake the bottles and test tubes to mix the solutions according to the instructions exactly (ie. shake bottle #2 for 30 seconds, shake final mix in test tube for 1 minute)... that makes a big difference in the accuracy of the measurements.


Hi Urban Aquaria,
Thanks for the tip.
I followed the API instructions exactly like you mentioned.
Think i have to do more water tests to verify if i am "noticing consistently high nitrate levels"..
Will be recording the data every two days.
Hope i am in the right directions..
Thanks!
Do note that the nitrate levels will naturally keep increasing unless there are enough plants to consume it or water changes are done to physically remove it... so if you see nitrates constantly rising (and want to keep it under control), just add more fast growing plants and/or do more frequent water changes.


Yeah, high nitrate levels are not as critical during fishless cycles, as there are no livestock yet that could be negatively affected... but excessive nitrate levels could still contribute to feeding algae growth instead (especially in a newly setup tank with low plant density and fluctuating parameters), so reducing the nitrates to more moderate levels can help to minimize algae issues.
Its best to try keeping the nitrate levels below 40ppm, ideally in the 10-20ppm range, enough for the plants to utilize yet not too high that it creates an imbalance in nutrient levels.
I'm guessing based on your current high nitrate levels that there are few plants in your tank (otherwise it wouldn't have accumulated to that much in such a short time), you could try temporarily adding fast growing floating plants like frogbits, salvinia natans/minima, dwarf water lettuce etc, to help soak up the excess nutrients that your other existing plants are not able to use.
Last edited by Urban Aquaria; 17th Apr 2015 at 19:16.

for api test kit do shake long enough like 3mins for NO3- as the ppm will change to darker as I tried so dun get the first reading as ur final reading. hope its helps
Bookmarks