feeding C02 into Ehiem 2213 external filter? how to do it?

[lance]

Hi folks,

I read about this somewhere but i can't find enough details to do it myself.

how do i feed CO2 into the output water stream of my Ehiem filter?

i have a bubble counter, two check valves, and a rain bar (from my ehiem filter)

pls advise. thanks

Lance

[lance]

Hi folks,

I read about this somewhere but i can't find enough details to do it myself.

how do i feed CO2 into the output water stream of my Ehiem filter?

i have a bubble counter, two check valves, and a rain bar (from my ehiem filter)

pls advise. thanks

Lance

[lance]

Hi folks,

I read about this somewhere but i can't find enough details to do it myself.

how do i feed CO2 into the output water stream of my Ehiem filter?

i have a bubble counter, two check valves, and a rain bar (from my ehiem filter)

pls advise. thanks

Lance

[lance]

Hi folks,

I read about this somewhere but i can't find enough details to do it myself.

how do i feed CO2 into the output water stream of my Ehiem filter?

i have a bubble counter, two check valves, and a rain bar (from my ehiem filter)

pls advise. thanks

Lance

[Simon]

u can directly feed the CO2 tubing into the inlet pipe (cut a hole big enuff then silicone).. i heard using this method cause the breaking down of the impeller

[David]

i will second simon on this one......it is possible but a big risk if you ask me....if too much CO2 gas gets into the chamber causing an air pocket, your impeller magnet will get scratch up pretty bad as it overheats.

[sherchoo]

Why don't you do the good ole fashion way and use a diffuser/reactor?

[BFG]

or external reactor?