Reply With Quotedo you mean your 2226 has no pump?
i'm using 2225, has remove the original pump (think it's 104replace it with 1260.
Intend to buy a 1260 pump to connect to my current 2226 canister filter.
Have read from the forum that some bro here do it with their 2028 filter but can't find any forum on this 2226. i am just worry that the 2226 can't take the pressure.
Can any bro here advice is it possible to connector as below?
1260 > 2226 > Co2 Reactor > tank
Must i put a control valve at the outlet of 1260?
do you mean your 2226 has no pump?
i'm using 2225, has remove the original pump (think it's 104
Originally Posted by lEddyl
do you mean your 2226 has no pump?
i'm using 2225, has remove the original pump (think it's 104
2226(flow rate 950L/h) is a canister with a build in pump. but i intend to remove the Impeller and drive it with 1260. Now worry that this canister can't take the pressure and still pending whether to buy this 1260 or not?
by the way is 2225 a canister?
sorry. mix-up!
mine is 2250. the dustbin
used to drive my 2028 with 1260. need to use tap as the pump too strong.
guess your 2226 is the same story.
When connect 2028 with 1260, if you don't use the tap, will the 2028 able to take the pressure?
My 2226 canister volume is much smaller than 2028.
will leak. the o-ring can't hold it
Last question, what is the hose size for the 1260 (inlet & outlet)?
Posting Permissions
Bookmarks