Advertisements
Aquatic Avenue Banner Tropica Shop Banner Fishy Business Banner
Results 1 to 4 of 4

Thread: UP regulator and cylinder

  1. #1
    Join Date
    Jan 2009
    Posts
    23
    Feedback Score
    0
    Country
    Singapore

    UP regulator and cylinder

    Advertisements
    Fresh n Marine aQuarium Banner

    Advertise here

    Advertise here
    any bro tried this regulator? Is it very difficult to control the bps since there is only 1 guage, without the lower pressure output and needle valve? After reading thru the forum, some say a single guage regulator is just like a on off valve only. I want to avoid hair pulling experience on setting the bps. But i'm looking for sleek cylinder and regulator. May i know which LFS carry the most UP products? Or any recommandation on the regulators with rather sleek design. My budget is within $250 for a full set including a 1L cylinder hopefully
    Last edited by bossteck; 16th Jan 2009 at 12:05. Reason: removed hotlinked image (copyright)

  2. #2
    Join Date
    Apr 2008
    Posts
    108
    Feedback Score
    0
    Country
    Singapore
    Hi jerra,
    I don't think that this regulator works like an on off valve only. In my experience, a singular gauge is good enough, just to estimate the amount of CO2 left in the cylinder. $250 would get you a fairly good deal of equipment at Petmart (Serangoon). I wont worry much about measuring bps because it is only a rough estimation of CO2 going into your tank. I do like to know the concentration of CO2 in the tank, thus a drop checker which is better investment though not the most accurate but it is more reliable than counting bps. Trust me, save the money up bro.

  3. #3
    Join Date
    Jan 2009
    Posts
    23
    Feedback Score
    0
    Country
    Singapore
    hi chris, i read from other threads saying those single gauge regulator is without the lower pressure gauge and without needle valve is very difficult to tune. and even its tune to the right amount of c02, after a few hours it will drop and eventually stop producing bubbles. which is very common among manuel regulator. my main concern is if i got to keep tuning once i see the co2 supply stop. that will be a nightmare. i have not tried using any pressurized c02 before that's why have to base on fellow bros experiences for me to choose the right system.
    Last edited by bossteck; 17th Jan 2009 at 00:07. Reason: spelling

  4. #4
    Join Date
    Dec 2001
    Location
    singapore
    Posts
    3,040
    Feedback Score
    0
    Images
    5
    Country
    Malaysia
    if you are looking for a simple to use/adjust co2 system, look for one with a proper regulator. such regulators usually comes with two gauges. add a needle valve and you'll have an easy time adjusting your co2 bubble rate. if you want to use a timer to start/stop the co2 injection, add a solenoid.
    thomas liew

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •