Do you want to tell us your water parameters before someone can comment? [:]
Last week I got myself Dr mallick's lusggro-micro. I add 10 drops into my 640L tank. The plants started bubbling like crazy and the HG start shooting out new leaves (can tell becos of the lighter green in color). And.... my algae also spreads like crazy at the same time. My nitrate is zero most of the time and I have to double dose my nitrate to keep them at 10ppm!
My question is, is this good, despite the algae boom which could be due to my high level of Phosphate, or should I do a daily dosage for my micros?





Do you want to tell us your water parameters before someone can comment? [:]
Cheerio,
Sleepy_lancs
*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*
An afternoon trimming my watery garden is better
then an afternoon with a therapist
*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*


sorrie.. a bit off the topic...
whr to find Dr mallick's lusggro-micro?? especially in the east??
Just a student with no income but a great passion for aquatic life.
size 6x2x2
lights 420W
PH 6.7
KH 3
Nitrate <10ppm
Phosphate 2ppm





What was your previous liquid fertilizing dosage, frequency and fertilizer's brand before you switch to Dr Mallick's Micro?
Hi,----------------
On 12/27/2003 1:28:24 AM
size 6x2x2
lights 420W
PH 6.7
KH 3
Nitrate <10ppm
Phosphate 2ppm
----------------
What kind of algae are you getting? I've a feeling you can increase your CO2 a bit more to keep up with that much light. Now it's probably less than 20ppm, according to the chart.
If you're doing weekly dosing, maybe can split the dose to every 2-3 days and see how the plants do.
Just add the micros to my already regiment of TMG.----------------
On 12/27/2003 12:12:27 PM
What was your previous liquid fertilizing dosage, frequency and fertilizer's brand before you switch to Dr Mallick's Micro?
----------------
My CO2 is already more than 10bps and already there is a column of CO2 in my internal reactor.----------------
On 12/27/2003 12:22:45 PM
Hi,----------------
On 12/27/2003 1:28:24 AM
size 6x2x2
lights 420W
PH 6.7
KH 3
Nitrate <10ppm
Phosphate 2ppm
----------------
What kind of algae are you getting? I've a feeling you can increase your CO2 a bit more to keep up with that much light. Now it's probably less than 20ppm, according to the chart.
If you're doing weekly dosing, maybe can split the dose to every 2-3 days and see how the plants do.
----------------





Your CO2 reactor isn't doing its job then. You might want to check if the water rate into the reactor is fast enough to mix with your co2. Perhaps you need a bigger reactor.
Cheerio,
Sleepy_lancs
*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*
An afternoon trimming my watery garden is better
then an afternoon with a therapist
*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*






Do a major scrub down of the tank and remove as much algae as you can find in the tank. Crank up the CO2 and drop the pH to 6.4-6.5 for the current KH. (It sounds like you need more flow through the reactor..Get a bigger pump for the reactor if needed and add mini-bioballs and scrubber dish pads to refrain the CO2 bubbles from blowing out the bottom.). TMG itself is good enough for the tank as traces. 40ml of TMG 2x per week is about the most that your tank would need with an iron rich substrate. Do not let the NO3 drop to zero or else you would stunt the plants...but I don't really trust your test kit though.
Regards
Peter Gwee![]()
Plant Physiology by Taiz and Zeiger
The powerhead to my reactor is at 2000L/hr! Let me see how I can lower my PH to 6.5.----------------
On 12/27/2003 5:01:06 PM
Do a major scrub down of the tank and remove as much algae as you can find in the tank. Crank up the CO2 and drop the pH to 6.4-6.5 for the current KH. (It sounds like you need more flow through the reactor..Get a bigger pump for the reactor if needed and add mini-bioballs and scrubber dish pads to refrain the CO2 bubbles from blowing out the bottom.). TMG itself is good enough for the tank as traces. 40ml of TMG 2x per week is about the most that your tank would need with an iron rich substrate. Do not let the NO3 drop to zero or else you would stunt the plants...but I don't really trust your test kit though.
Regards
Peter Gwee![]()
----------------
I add potassium nitrate into a seperate pail of water and test it with my sera nitrate test. The reading turns up ok with expected high reading. But every night I add 2 spoons of potassium nitrate, the next morning I got some reading at 5-10ppm and by evening, it goes to 0-5ppm. My phosphate is still at 2ppm... I am trying to dilute my phosphate with more frequent large water change till it drop to 1ppm. Now I cut down my photoperiod to 8 hrs.






All this does not sound right...Your nitrate is dropping extremely fast while your phosphate does not move at all? This cannot be..it has to drop as fast if not faster than the nitrate. Cheapo test kits are not really cut out for the precision low range folks need to target for. Unless you are pulling out kilos of plants week after week, I doubt your tank is eating at 5ppm(max) per day.
Regards
Peter Gwee![]()
Plant Physiology by Taiz and Zeiger
hmmm... what do you recommend for a nitrate tester... I am using sera test kit... I have used over 2 sets of nitrate and they are both giving me consistance results.
I am using root monster... could this stuff be leaking phosphates into the water column?






Good test kits are hard to get and most likely beyond the budget of aquarist. Imagine paying a couple of hundreds for a test kit...are you willing to?
Are you getting loads of plant growth week after week? With such strong plant growth, you should not be having issues with algae unless you slack on the dosing and let the nutrients run out. You mention your NO3 ran out a couple of times? Maybe that could be your problem....You can trust your kit for now and dose accordingly and never let the NO3 run out to see if it helps. Make sure the CO2, K ,PO4 and traces are also in good range and things should recover and look good in 3-4 weeks.
You really don't need that kind of accuracy with PO4. Just dose slightly less than 1/4tsp of KH2PO4 2x per week should be fine.
Large weekly water changes is the key here but if you feel its a waste of water then I would rather you go the low light no CO2 way especially with such a big tank. No water changes except once every few months when the plants grow in a bit.
Regards
Peter Gwee![]()
Plant Physiology by Taiz and Zeiger




Hi Peter,
Can you please elaborate on your KH2PO4 dosage? May I know what tank size were you referring to with your recommended dosage? I juz started dosing P recently. Currently experimenting and some directions will be good. Thanks.
Cheers!
wow...I paid 70 bucks for the PH test pen... but well used. How much is a good nitrate test kit? Which brand and where can I get it. If the test kit can last > 1 year, I guess it is worth it.----------------
On 12/28/2003 4:42:18 PM
Good test kits are hard to get and most likely beyond the budget of aquarist. Imagine paying a couple of hundreds for a test kit...are you willing to?
hahah... that was my problem, when I got my potassium phosphate, I got so excited that i dump 3 large teaspoon!!You really don't need that kind of accuracy with PO4. Just dose slightly less than 1/4tsp of KH2PO4 2x per week should be fine.
I have to 'reset' my nutrient level thru large water change and monitor again. Thanks for your advise.






Lamotte and hach are 2 good brands that I have heard. You might be able to get the hach kit more easier than the lamotte in singapore as I heard my lab friend saying that they use hach test kits and chemicals for testing.Lamotte from what I have heard from in this forum cost up to $300-$400??? [
] A big hole in the wallet for sure.
Regards
Peter Gwee
Plant Physiology by Taiz and Zeiger






Kadios, it kind of depends on the amount of light you have over the tank, plant load, bioload and type of plants. But generally saying, 1ppm 2-3 times a week sounds about right. Note that you need the CO2 to be in good shape for all the stuff to do its work though. Don't blame the PO4 if you get algae after adding it as it won't. Good luck.
Regards
Peter Gwee![]()
Plant Physiology by Taiz and Zeiger






NO3 getting used up so fast? Do you have anything in the filter that removes ammonia or nitrates? Eg. Zeolite?----------------
On 12/28/2003 12:47:17 AM
The powerhead to my reactor is at 2000L/hr! Let me see how I can lower my PH to 6.5.----------------
On 12/27/2003 5:01:06 PM
Do a major scrub down of the tank and remove as much algae as you can find in the tank. Crank up the CO2 and drop the pH to 6.4-6.5 for the current KH. (It sounds like you need more flow through the reactor..Get a bigger pump for the reactor if needed and add mini-bioballs and scrubber dish pads to refrain the CO2 bubbles from blowing out the bottom.). TMG itself is good enough for the tank as traces. 40ml of TMG 2x per week is about the most that your tank would need with an iron rich substrate. Do not let the NO3 drop to zero or else you would stunt the plants...but I don't really trust your test kit though.
Regards
Peter Gwee![]()
----------------
I add potassium nitrate into a seperate pail of water and test it with my sera nitrate test. The reading turns up ok with expected high reading. But every night I add 2 spoons of potassium nitrate, the next morning I got some reading at 5-10ppm and by evening, it goes to 0-5ppm. My phosphate is still at 2ppm... I am trying to dilute my phosphate with more frequent large water change till it drop to 1ppm. Now I cut down my photoperiod to 8 hrs.
----------------
koah fong
Juggler's tanks
Are you using Seachem Prime water conditioner? It removes ammonia and nitrates. I've done a test on that before. NO3 reading went down to 0ppm after adding it.
Bookmarks