diy acrylic

[gentle]

i custom made some 5mm acrylic pieces

but after collecting the pieces, found that i need to trim off 1-2 cm and also drill extra holes...

can i know whether i need to use specialised tools to do it? or a normal saw + drill will do?

[ken1971]

Bro,
Just use pen knife to cut will do. I just cut 2 pieces recently.

As for drilling, use only small drill bit should be fine.

Ken

[diazman]

You can also use those acrylic abrasive paper and sand them away. At the same time smoothing the sides.